. OPERATION EXPLANATION OF COMPONENTS 3 - 42 ACCELERATOR P This pe dal (2) is u sed to adju st the It can b e operated freely between t he e ngine low idle position and the full throttle pos GEAR SHIFT LEVE The ge ar range c travel c onditions. Positio n D: used when traveling normally. When this position is used, This is ormally. ition is used, the tra nsmission is set automatically between the 2nd torque conver ter drive an d 6th gear according to the travel speed. While the du mp body is r aised, however, the transmission i s fixed to the 2nd ge ar and is no t changed. Keep the dump body lo wered during travel. The maxim um travel speed in this position is 57.1 km/h spee (35.5 M PH).
REMAR K In conformity with t he EU safe ty rule (EN474-6 5.1.3), the gear shift lever is restricted t o the 2nd speed and cannot be sh ifted in the D positio n, when the machine i s running while the dum p body is not fully lo wered to its seat. Positio n R1: This is used when traveling in reverse. When this po sition is used, the transmission is fixed in R1 and the trav el is carried out in torqu e converte r drive or direct drive acc ording to the travel speed. The maxim um travel speed in this positio n is 7.2 km/ h (4.5 MPH ). Positio This is used when traveling in reverse.
When this po sition is used, the transmission is fixed in R2 and the trav el is carried out in torqu e converte r drive or direct drive acc ording to the travel speed. The maxim um travel speed in this positio n is 17.0 km /h (10.6 M PH). The ma chine cann ot travel in reverse w hile the dump body is raise d. Lower the dump body a nd set the dump l ever in the " FLOAT" po sition, and then set i t in the "R1" o r "R2" position