TRANSPORTING Loading d WARNING: Always travel the machine slowly. Steering on a ramp may create a danger of tipping over. Never attempt to change travel direction on a ramp, possibly causing the machine to become unstable. If steering is unavoidable, first move back to the ground, modify traveling direction, and begin to drive again. The top end of the ramp where it meets the flatbed, there is a sudden bump. Slowly drive over it. Use extra care when rotating the upperstructure on the flatbed to prevent possible injury from machine tipping. Slowly rotate the upperstructure with the arm fully rolled in under the boom to maintain good machine stability. 1.
Load the machine on the trailer so that the centerline of the machine aligns with the centerline of the flatbed. 2. Drive the machine onto the ramp slowly. 3. Position the bucket above the flatbed. Operate the front attachment so that the angle between the boom and the arm is maintained at 90 to 110°. 4. The machine tips forward when the machine travels over the top end of the ramp. Lower the bucket onto the flatbed before the machine begins to tip forward. 5. After the machine reaches the specified position, slightly lift the bucket up off the flatbed. Slowly rotate the upperstructure 180° while keeping the arm fully rolled in. M1M7-06-001 Less than 15˚ 6.
Lower the bucket on wooden blocks seated on the flatbed. 7. Stop the engine. Remove the key from the switch. 8. Move the pilot control shut-off lever to the LOCK position. 9. Cover the openings on the machine to prevent wind and/or rain from coming in. d CAUTION: During cold weather season, be sure to sufficiently warm up the machine before loading or unloading the machine. 6-2