hitachi — Hitachi ZX14-3/ZX16-3/ZX18-3/ZX27-3 Hydraulic Excavator Operator's Manual

MAINTENANCE 6. Remove oil filter (5) from the engine by turning it counterclockwise using a filter wrench. 7. Coat the gasket of new filter (5) with engine oil. Turn the filter clockwise by hand until the gasket touches the sealing surface. 8. Tighten oil filter (5) 3/4 turns more using the filter wrench. Take care that oil filter (5) may become deformed if excessively tightened. Tightening torque: 20 to 24 N·m (2.0 to 2.4 kgf·m, 14.5 to 17 lbf·ft) 9. Remove oil filler cap (6). Refill the engine. f NOTE: Refer to the recommended oil and grease chart on 6 7 5 M1NC-07-005 ZX14-3, 16-3, 18-3 page 7-9 for the brand names of oils. 10.

Check that oil level is between the upper and lower limit 6 11. Check that no oil is leaking from the sealing joints. marks on the dipstick (7). Start the engine. 12. Run the engine at slow idle for 5 minutes. Stop the 7 engine. About 15 minutes later, recheck the oil level. Add as needed. 13. Tighten bolt (2) to install undercover. IMPORTANT: Do not re-use the engine oil filter (5). Be sure to use only genuine engine oil filter (5). Failure to use genuine parts or replace oil filter (5) may damage the engine. 5 ZX27-3 M1NC-07-029 7-23