MAINTENANCE 3. Remove the radiator cap (5). Open drain cock (6) on the radiator and open drain valve (7) on the water jacket to drain the coolant completely. Drain impurities such as water scale at the same time. 4. Close radiator drain cock (6) and drain valve (7) on the water jacket. Fill the radiator with fresh water and a radiator cleaning agent. Start the engine and run it at a speed slightly higher than slow idle to raise the coolant temperature until indicator goes OFF. Then, run the engine further for about ten minutes. 5 5. Stop the engine and open radiator drain cock (6) to allow ZX14-3, 16-3, 18-3 M1NC-07-019 the coolant to drain.
Flush out the cooling system with fresh water, until draining water becomes clear. This helps remove water scale. 5 6. Close radiator drain cock (6). Fill the radiator with fresh water and LLC at the specified mixing ratio. When adding coolant, do so slowly to avoid mixing air bubbles in the system. Run the engine to sufficiently bleed the air from the cooling system. 7. After adding coolant, operate the engine for several minutes. Check the coolant level again, and add coolant if necessary. 8. Close radiator cap (5). 9. Tighten bolt (4) to install cover (3) under the engine ZX27-3 M1NC-07-030 10. Tighten bolt (2) to install right cover (1). cover.
6 ZX14-3, 16-3, 18-3 M1NC-07-020 M1NC-07-034 6 ZX27-3 7 ZX14-3, 16-3, 18-3 M1NC-07-021 7-57