hitachi — Hitachi ZX14-3/ZX16-3/ZX18-3/ZX27-3 Hydraulic Excavator Operator's Manual

MAINTENANCE I. Miscellaneous Check Bucket Teeth for Looseness and/or Wear --- daily 1 4 5 1 Check the bucket teeth for wear and looseness Replace teeth (1) if tooth wear exceeds the service limit shown below. A Dimension A in mm (in.) New Limit of Use 128 (5.0 ) 65 (2.6 ) M104-07-056 2 d WARNING: Guard against injury from flying pieces of metal. Use safety equipment such as a helmet and safety glasses. 3 1. Use hammer (2) and drift (3) to drive out locking pin (5). Be careful not to damage rubber pin lock (4) while removing locking pin (5). 2. Inspect locking pin (5) and rubber pin lock (4) for any damage, replace if necessary.

Short locking pins (5) and damaged rubber pin locks (4) must be replaced with new ones. M589-07-017 RIGHT WRONG 5 Level the bottom surfaces. Lock pin length is too short. M104-07-118 M104-07-058 4 Steel balls almost come off due to damage to the lock rubber. Steel balls can be depressed by finger force. M104-07-059 7-64 G WRON G WR ONG