hitachi — Hitachi ZX14-3/ZX16-3/ZX18-3/ZX27-3 Hydraulic Excavator Operator's Manual

MAINTENANCE 6 Clean Cab Floor (Cab Equipped Machines) --- as necessary IMPORTANT: Only the cab floor can be washed with water. Take care not to splash other parts of the cab with water. Do not increase the water pressure speed by squeezing the hose end. Never use steam to clean the cab floor. Always clean the cab floor only after closing ducts (1 and 2) to prevent water from entering the duct. Failure to do so may result in malfunction of the heater. If the box located under the seat is splashed with water, failure of the inside electrical parts may result. 1 2 ZX14-3, 16-3, 18-3 M1NC-01-004 1. Park the machine on a level surface. Lower the bucket to the floor. Stop the engine. 2.

Sweep the dust out of the cab floor and the pedals with a brush, or use a brush while directing water. (Sweep out the mud and bust with a brush as much as possible before applying water.) 3. When cleaning the floor mat, sweep out the dust and/or water along the grooves on the floor mat. 4. When cleaning the cab floor with the floor mat removed, remove only the rear mat. Then, sweep the dust and/or water through the steps. 5. If water permeation is recognized, run the blower at the maximum speed for several minutes until water drops disappear. Turn the heater OFF at this time. M1NC-01-021 1 ZX27-3 7-75