SAFETY Remove Paint Before Welding or Heating Hazardous fumes can be generated when paint is heated by welding, soldering, or using a torch. If inhaled, these fumes may cause sickness. Remove paint before welding or heating. Avoid potentially toxic fumes and dust. Do all such work outside or in a well-ventilated area. Dispose of paint and solvent properly. Allow fumes to disperse at least 15 minutes after welding or heating. Use attention to the following points when removing paint. 1. If you sand or grind paint, avoid breathing the dust which is created. SA-029 Wear an approved respirator. 2. If you use solvent or paint stripper, remove stripper with soap and water before welding. 3.
Remove solvent or paint stripper containers and other flammable material from area. Prevent Battery Explosions Battery gas can explode. Keep sparks, lighted matches, and flame away from the top of battery. Never check battery charge by placing a metal object across the posts. Use a voltmeter or hydrometer. Do not charge a frozen battery; it may explode. Warm the battery to 16 °C (60 °F) first. Do not continue to use or charge the battery when the electrolyte level is lower than specified. Explosion of the battery may result. When a terminal become loose, it may induce sparks. Securely tighten all terminals. SA-032 Battery electrolyte is poisonous.
If the battery should explode battery electrolyte may be splashed into eyes, possibly resulting in blindness. If electrolyte is splashed into eyes, flush your eyes continuously with water for about 15 minutes. Seek medical attention immediately. Be sure to wear eye protection when checking electrolyte specific gravity. S-30