hitachi — Hitachi ZX14-3/ZX16-3/ZX18-3/ZX27-3 Hydraulic Excavator Operator's Manual

DRIVING MACHINE Traveling on Soft Ground Avoid traveling on soft ground as much as possible. If traveling on a soft ground is unavoidable, carefully operate the machine while observing the following points. Drive the machine as far as the machine can move by own propelling power. Towing machine may become necessary. Do not drive the machine to a deeper location than towing machine is possible. In case it becomes impossible for the machine to travel by own propelling power, lower the bucket to the ground. While supporting the machine weight with the boom and the arm, slowly pull the arm to evacuate the machine.

Operate the boom, arm, and travel levers simultaneously at this time to prevent the machine from being loaded abnormally. If the track frame bottom comes into contact with the ground, or if mud and/or grabbles are tightly packed into the undercarriage, the machine may become impossible to travel. Raise one side track above the ground with the boom and arm extended, remove mud and/or grabbles from the track. Then, evacuate the machine. Rotate the raised track in forward or reverse directions alternately to remove the packed rocks and/or mud from the track. Tow the machine with other machine if the machine becomes stuck in soft ground and impossible to evacuate by own propelling power.

Refer to the descriptions for Towing Machine on the next page for the correct rope attaching method. M1M7-04-005 Raise One Track Using Boom and Arm d WARNING: Operate the machine carefully. The machine may slide. Keep the angle between boom and arm 90 to 110 ° and position the bucket’s round side on the ground. 1. Swing the upperstructure 90 °. 2. Position the boom and the arm so that the angle 90 to 110˚ between them becomes to 90 to 110 °. Push the ground with the round bucket bottom to raise track off ground. 3. Do not raise the track with the boom and the arm when the boom is swung. M1M7-04-005 4-4