Komatsu — 22.5.1 CHANGING THE BUCKET

USING THE WORK EQUIPMENT 22.5 CHANGING THE WORK EQUIPMENT DANGER Metal splinters may form when link pins are being fitted or removed. Always wear gloves, goggles, and a hard hat when performing these operations. The assistance of a second person is required in order to change equipment. Make sure that both of you agree on the words, phrases, and signals to be used. Never use your fingers to check on the alignment of holes. Unexpected movement can easily sever fingers. 22.5.1 CHANGING THE BUCKET 1 - Lower the bucket so that the flat back rests on flat ground. 2 - Remove, in this order, the bucket cylinder ram link pin (1) and then the arm link pin (2). 3 - Replace the bucket.

Clean the link pins and the bushings, and lightly grease the link pins before fitting. 2 3 1 IMPORTANT Fit the arm link pin first, making sure that the sealing washers are in good condition. 3 F00166 4 - Replace the link pin safety clips (3) and lubri- cate the link pins through the grease nipples. 90