Komatsu — 23.2.1 USING JUMP LEADS TO START THE ENGINE

FAULT FINDING 23.2.1 USING JUMP LEADS TO START THE ENGINE DANGER When starting the engine from the battery of another machine, connect the two bat- teries in parallel. Avoid contact between the positive (+) and negative (–) leads when making connec- tions. Always wear safety goggles when starting the engine from the battery of another machine. Make sure that the two machines do not come into contact with each other. Acci- dental contact could lead to sparks and consequently explosions of the hydrogen produced by the batteries.Battery explosions can cause serious damage and injury. Make sure that you do not get the two jump leads mixed up.

Connect the negative (–) lead last, and as far as possible away from the battery. Take great care when removing jump leads. Make sure that they do not come into contact with any part of the machine when disconnected from the battery. Acciden- tal contact can lead to sparks and hydrogen explosions. IMPORTANT Jump lead thickness and clamp size should be proportional to the current to be carried. The battery used for starting should be of equal or higher capacity than the flat battery. Make sure that the jump leads and clamps are not corroded. Check that the clamps grip the terminals securely.

CONNECTING THE JUMP LEADS AND STARTING THE ENGINE 1 - Make sure that the ignition key is in position « O ». 2 - Connect the positive (+) terminals of the two batteries together (A). 3 - Connect the negative (–) terminal of the charged battery to the frame of the machine to be started (B). 4 - Start the engine of the machine with the charged battery and accelerate it to a high speed. 5 - Start the engine of the machine with a flat bat- tery. (See section 16.2 «STARTING THE ENGINE».) D00023 A 2 1 1 Spent battery Charged battery B Engine block to be starded 2 92