Komatsu — 29.6.g CHANGING THE ENGINE OIL

SCHEDULED MAINTENANCE Replace this filter every time you replace the hydraulic system return line filter. Open the bonnet to gain access to the servocon- trol filter, and proceed as follows: 1 - Unscrew the filter body (1) and remove the old filter element. Use the 22 mm wrench. 2 - Clean all the filter parts, including the inside of the filter body (1) and fit a new filter and seal. Reassemble in the reverse order. 1 IMPORTANT Start the engine and leave it idle for 2 ч 3 minutes after the new filter is fitted. F00848 29.6.g CHANGING THE ENGINE OIL DANGER The engine oil is extremely hot when the engine has just been switched off. Leave it cool to 40 ч 45 ° C before draining it off.

Oil spilled during oil changes can cause people to slip. Wear anti-slip shoes, and clean up spilled oil immediately. Lubricants, filters, coolants, and batteries are special waste products and must be disposed of in compliance with local waste disposal laws. To drain off the old oil, remove drain plug (1) from the sump. Also remove filler cap (2) to enable the oil to flow out more easily. When all the old oil has drained out, replace drain plug (1) and fill the engine with the specified quantity of new oil. Check that the level comes up to the MAX mark on the dipstick (3). Use the 16 mm wrench. Replace the filler cap. Run the engine for 5 minutes; switch off again and check the oil level.

Top up if necessary. Use oil suitable to the ambient temperatures. (See section «26. FUEL, COOLANT, AND LUBRICANTS»). 2 MAX. MIN. 1 3 F00192 F00849 125