AUTHORISED OPTIONAL EQUIPMENT 32.2.2 REMOVING THE DEMOLITION HAMMER Proceed as follows to remove the demolition hammer. 1 - Park the machine on firm, level ground and deposit the demolition hammer flat on the ground where it can rest securely when removed. 2 - Switch off the engine and move all the controls a few times to release any residual pressure from the hydraulic system. 3 - Turn the ignition key to position « I » and press down on the demolition hammer control push-button to release pressure from the hammer circuit. 4 - Return the ignition key to position « O » and remove it. 5 - Use 41 and 50 mm spanners to disconnect the delivery and return hoses from the ham- mer.
6 - Seal the ends of the hoses with sealing plugs. DANGER Make sure that the sealing plugs are tight. If the hammer circuit is accidentally pressurised, jets of hydraulic fluid can escape from loose plugs and can cause serious injury if they come into contact with the skin or eyes. Wear thick gloves and safety goggles when searching for leaks in the hydraulic system. Use a piece of cardboard or wood to search for hydraulic leaks, NOT your hands. 7 - Remove the coupling pins to remove the hammer. See section 22.5.1 UNCOUPLING BUCKETS. 150