Komatsu — 33.2 FITTING THE CLAMSHELL BUCKET

AUTHORISED OPTIONAL EQUIPMENT CAUTION Before starting work with the clamshell bucket, make sure that the selector lever (2) is turned clockwise as far as it will go. F00711 2 33.2 FITTING THE CLAMSHELL BUCKET DANGER Park the machine on firm, level ground and lower the equipment to the ground before starting to fit the clamshell bucket. Wear thick gloves, safety goggles and a hard hat when fitting the clamshell bucket. Splinters of metal can form when the coupling pins are fitted and removed. Two people are required to fit and remove the demolition hammer. Agree on instructions and signals before you start work. Never use your fingers to check on the alignment of holes.

Fingers can easily be sheared by unexpected movement. Move all the controls a few times and remove the hydraulic tank filler cap to elimi- nate all residual pressure from the hydraulic system before starting work. Clean up any oil or fluid spillages immediately. Proceed as follows to fit the clamshell bucket: 1 - Remove the standard bucket as instructed in section 22.5.1 UNCOUPLING BUCKETS. 2 - Fully retract the bucket control cylinder. 3 - Couple the clamshell bucket to the end of the arm. 4 - Stop the engine and move all the controls a few times to release all residual pressure from the hydraulic system.

5 - Turn the ignition key to position « I » and operate the clamshell bucket rotation switch to release all residual pressure from the rotation circuit. 6 - Return the ignition key to position « O » and remove the key. 7 - Lock the standard bucket thrust lever in place with the piston at the end of its stroke. 152