Komatsu — STARTING ENGINE

. OPERATION OPERATION STARTING ENGINE WARNING 1. Turn the key in starting switch (1) to the ON position. For machines not equipped with a prelube system, go on to Step 2. REMARK When the prelube is completed in Step 3), leave for at least 70 seconds (including the preheating time). The condition will return to the condition in Step 1). FUNCTION WHEN 3 - 91 Sit down in the oper Do not attempt to sta ator's seat before starting the engi rt the engine by short-circuiting the ne. engine starting circuit. Such an act Check that there are may cause serious bodily injury or fire. no persons or obstacles in the surrounding area, then sound the horn and start the engine. Exhaust gas is toxic .

When starting the engine in confi ned spaces, be particularly careful t o ensure good ventilation. NOTICE Do not keep the start ing motor rotating continuously fo r more than 20 seconds. If the engine will no minutes before tryin g to start the engine again. armed up. Avoid the sudden ac celeration of the engine until it is w For machines equipp ed with a prelube system icator lamp (2) is flashing, it is necessary to ube. icator lamp (2) is not flashing, go on to Step in starting switch (1) to the START position, to the ON position.

y is released, it will automatically return to the ator lamp (2) will light up and the prelube will 1) If prelube ind carry out prel If prelube ind 2) Turn the key then return it (When the ke ON position.) Preview indic start. 3) The prelube i (The prelube s completed after approx. 5 - 6 0 seconds, and the prelube indicator la actuation time differs accordin g to the ambient temperature and the en icator lamp (2) is not flashing, in starting switch (1) to the ST go on to Step ART position, to the ON position.

y is released, it will automatically return to the ator lamp (2) will light up and th e prelube will In cold weather, the o il viscosity is high, so there ma y be cases where the prelube is not co this case, operate it f or 60 seconds, then return to th e condition in Step 1), wait for approx. 60 the procedure from S tep 2. If the prelube is not c ompleted even when it is carrie d out 3 times, there is probably an abn system, so contact y our Komatsu distributor for ins pection and repair. (For details of the m ethod of starting the engine STARTING IN EMER GENCY (PAGE 3-170)".)