Komatsu — REMOTE POSITIONER

. OPERATION OPERATION REMARK ADJUSTING REMOTE POSITIONER been removed or the setting does not work efficiently, please contact your Komatsu 3 - 114 SENSOR ADJUSTMENT MET 1. Set th e wor k equipm ent to the lift arm top end p 2. Keep remo te position er LOWER position set s witch (1 remo te positioner RAI SE position set switc h (2) pressed at the same time f or at leas t 3 seconds. When remo te position er LOWER s et pilot l amp ( 3) and re mote positioner RAISE se t pilot lamp (4) lig ht up , releas switches an d set to th e sensor ad justmen t mod 3.

The r emote positione r LOWER se t pilot l amp ( mote positioner R AISE set pilot lamp (4 ) light up for 2 seconds , and when both l amps go out, the offse t is recorded in memo 4. If the lamps flash in Step 3, the potentiometer output i s not within the o ffset rang e, so adjust t he potentiometer mou Adjustment can be ca rried out at t he posture in After adjustmen t each pot entiometer,always c arry o ut Steps 1 and 2 again, and ch eck that t he condition in Step 3 is c orrect (th e set lamps lig ht up f or 2 seco nds and then go out) When th e lift a rm has b distributo r for a djustment