. MAINTENANCE SERVICE PROCEDURE 3. Remove outer element. 4 - 23 CLEANING OR REPLACI 1. Open cover (2) at th e rear of the operator's comp artment. 2. Remove lock (3) of t he cover, then remove cover 4. Clean the inside an d the cover of the air cleaner 5. Direct dry compress ed air (less than 0.2 MPa {2.1 kg/cm2, 30.0 folds, then PSI}) to the outer e direct it from outside 1) If the air clean immediately aft replace both the lement from inside along its along its folds and again fro m inside. er clogging caution pilot la er the outer element has be mp flashes en cleaned, inner and outer elements. NOTICE After cleaning and drying t he element, check it by shining a light through it.
If any small holes or thin cracks are found, replace the ele ment. ything. seals. When cleaning the element , do not hit it or beat it against an Do not use an element that has damaged folds, gaskets, or 6. After cleaning the el ement, install it, then install c over (4). 7. After cleaning and replacing the element, pus h the dust indicator button to re turn the red display to its origi nal position. REMARK After cleaning the indicator. If the dust i the button is pressed element, press the button ndicator shows the 5th stage of the dust even when , replace the element. cleaned or replaced with a new element, y show the 3rd stage. After the element is the dust indicator ma