Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CHECK AXLE OIL LEVEL, ADD OIL WARNING Tightening torque: 127 to 177 Nm (13.0 to 18.0 kgm, 94.0 to 130.2 lbft) 4 - 30 The parts and oil a re at high temperature imm ediately after the e ngine is stopped, and ma y cause burns. Wait fo r the temperature to go down befor Perform this pro cedure if there is any si gn of oil on the a xle case. Inspect the mac hine on a horizontal sur face. (If the road surf ace is at an angle, the oi l level cannot be checked correctly.) chine in a horizontal place. 1. Stop the ma 2. Stop the en 3. Remove lev 4. Check that 5. If the oil is n oil filler (F). 6. If the oil lev 1. Stop the ma chine in a horizontal pla 2.

Stop the en gine, then wait for the oi l temperature to go down. 3. Remove lev el plug (1). the oil level is near the bottom of the plug hole. 4. Check that the oil level is near the b ottom of the plu 5. If the oil is n ot near the bottom edge of the hole, add o il through el is correct, install level plug (1) 6. If the oil lev el is correct, install level CLEAN AXLE CASE BREATHER 1. Stop the ma 2. Stop the en 3. Use a brus breather. 4. After remov remove the When clean (front and re After remov from enterin 5. Install the b When clean (front and re 1. Stop the ma chine in a horizontal pla 2. Stop the en 3. Use a brus breather, and soak it in flushing liquid to clean it.

ing the breather, clean th e breathers at t wo places ar). ing the breather, take st eps to prevent d irt or dust g the mount. reather. 5. Install the b ing the breather, clean th e breathers at t wo places ar).