. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE new NOTICE 4 - 58 Remove transparent cup (2) from the filter and inspect it. broken or damaged, rep Clean transparent cup (2 lace it with a new part. ) and remove seal (3). Coat the seal with clean fuel or oi 4. Install transparent cup (2 Tightening torque for cu 5. Clean the filter holder, cartridge thinly with oil, t NOTICE When adding fuel, do not re move cap (B). Always add fuel from s mall holes (A) on the dirty s ide. (B) and install the fuel filter. A fter adding fuel, remove cap A lways fill with clean fuel. Be careful not to let any dirt or dust g t c p he fuel.
In particular, center p ortion is the clean side, so do not re ap (B) when adding fuel. Be careful not to let dirt or dust get into ortion on the clean side. 6. When installing, tighten u ntil the packing surface contact s the seal surface of the fil ter holder, t hen tighten it 3/4 of a turn. If the filter cartridge is tig htened too far, the packing will be damaged and thi s will l ead to leakage of fuel. If the filter cartridge is too loos e, fuel will also leak from the pa cking, so always ti ghten the correct When tightening with a filter wrench, be extremely ca reful not t o dent or dama ge the filter. 7. Start the engine and run it at low idling for approx.
10 mi nutes unti l th e engin e spe ed stabilize s. Check fo r any sucking in of air or leaka ge of fuel from the transparent cup and s eal surfac e of th e filter cartridge. When replacing the fuel main fil ter cartridge, bleed the air after repl acing the f ilter cartrid For details, see "REPLACE FUE L MAIN FILTER CARTRIDGE (PAGE Do not fill the fuel main filter car