Komatsu — PRECAUTIONS FOR INSPECTION AND MAINTENANCE

. SAFETY PRECAUTIONS FOR MAINTENANCE from touching touched by hand. Then loosen the cap or plug slowly to release the internal pressure and remove the cap or plug. place with clean water, and consult a doctor immediately for and lead to serious to be leaking from the 2 - 42 PRECAUTIONS WITH HIGH-TEMPERATURE OIL To prevent burns from hot oil spurting out o To prevent burns high-temperature pa the oil to cool down t rts when checking or drainin o a temperature where the c PRECAUTIONS WITH HIGH-PRESSURE OIL Th e hydraulic syste m is always under internal pr essure.

In addition , the fuel piping is als o under internal p ressure when the engine i s running and immediately after the engine is stopped. When c arrying out inspe ction or replacement of the piping or hoses, check that th e internal pressu re in the circuit has b een released. If th is is not done, it may lead to serious personal injury or d eath. Always do a Do not carry out i nspection or replacement wo rk with the circuit I Always release t he pressure before starting. NSPECTION AN D MAINTENANCE (PAGE I f there is any leak age from the piping or hoses , the surrounding a rea will be wet, so ch eck for cracks in th e piping and hoses and fo r swelling in the hoses.

When carry out in spection, wear safety glasse There is a haza holes may pene rd that high-pressure oil lea trate your skin or cause lo n or eyes directly. If you a contacts your ski high-pressure oil and suffer injury to your skin o PRECAUTIONS WITH HIGH-PRESSURE FUEL When the engine is running, high-pressure is gen erated in the engi ne fuel piping. When carrying out insp ection or maintenance of the fuel piping system, stop th e engine and wait for at least 30 seconds to allow the internal n. internal pressure to go dow n before starting the operatio HANDLING HIGH-PRESSURE HOSES AND PIPING If oil or fuel leaks from high-pressure hoses I f oil or fuel leaks I personal injury, o r death.

If the hose or pipin mount, stop oper ations and tighten to the spe f any damaged o r deformed hoses or piping are found, please consult your Komats Replace the hose if any of the following problem Damaged hose o r deformed hydraulic fitting. Frayed or cut co vering or exposed reinforcem Covering swollen Twisted or crush Foreign material