Komatsu — CONTROLLER

. OPERATION DETAILED CONTROLS AND GAUGES FUSIBLE LINK Fusible link (2) is taped to the nearby wiring carrying out inspection or replacement, check number. the high current flow portion of the circuit to protect CONTROLLER Controller installed. 3 - 108 If t he st arting motor does no t turn when the starting switch is to the S TART position, ther e is probably a disconnection in link (1) or (2). Open the ba ttery box cover on the right side chassis , then check and re place the fusible link (1): Fu sible link for 24V pow (2): Fu sible link for 24V per harness.

he REMAR A fusib installed electric al components and wiring from burning, in the sam NOTICE reful not to get water, mud, or juice on the controller. This will cause failure. Be ca reful not to get water, mud, or juice on the controller . This The e ngine controller has be en given moisture prevention treatment, so there is no problem if rain gets on it, but do not spray it wit h water when washing the machine. the controller, do not disassemble it yourself. Contact your Komatsu distributor for repairs. If any abnormality occurs in the controller, do not disassemble it yourself. Contact your Komatsu Engi Ope ne controller n the front engine ho od.It is under the fuel pre-filter.

Pum This is on the right side a t the rear of the operator's seat