Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Rearview Mirrors WARNING 3 - 121 Be sure to adjust the mirrors before starting w ork. If the y are not adjusted properly, you cannot s ecure the visibility an d may be injur ed or ma y injure some one seriously. When a djusting t he angle of t he mirror over th e counterweight, p rovide a secure scaffold using a step ladder and then carry out the work. Do not do the wo rk standing on th e counterweight, a s there is always the danger of a serious injury due to f alling- off from Mirror (A) e mirror mount so that it is possible to see people at the f the machine. Adjust th e mirror rear left o f the machine.

Install the side view mirror in the location indicate d in the f igure at right . mm (2.4 in) rror securing stay (1) the way the side view mirror es outward to the maximum. (L): 60 mm (2.4 Fix mi stretch es outward to the m If the s ide view mirror doe s not move sm oothly w hen adjusting its angle, loosen mirror securing bolt (2) and mirror securing stay bolt (3). Tightening torque of bolt (2): 7.85 - 9.81 Nm (0.8 - 1.0 kgm, 5.8 - 7.2 lbft) its ang le, loose n mirror sec uring bolt (2) an d mirror securing stay bolt (3) Tightening torque of bolt ( 2):

7.85 - 9.81 (0.8 - 1.0 kg m, 5.8 - 7.2 When adjusting the side vi ew mirror angle , make an adjustment so that the side of the mac hine comes into view o n the mirr or as shown in the fi gure at right .