Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC).

If you use another coolant, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. Supercoolant (AF-NAC) is already diluted with distilled water. When using coolant, investigate the lowest temperatures in the past and decide the density for the coolant from the coolant density table below. When actually deciding the density for the coolant, set it for a temperature 10 ° C (18 ° F) lbelow the actual temperature. The coolant density varies according to the ambient temperature, but it must always be a minimum of 30%.

Coolant density table 4 - 25 Immediately after th e engine i s stopped, t he coolant is at a high temperatu re and th e radiator is under high interna l pressure. If the cap is r emove d to drain t he coolant in this conditi on, there is a hazard of burns. Wait for the temperature to go down, then turn t he cap slowly to release the pressur e before removing it. When starti the the movin For d etails o f starti ng the engi ne, see "BEFORE STARTING ENGINE (PAGE 3-110)" and "STARTING ENGINE (PAGE 3-129)" in the O PERATION se ction. e fan if the undercover is left removed. ne when the engine is running.

There is danger of t ouching th e fan if the undercover is left remove Never enter behind the machi ne when the engine is ru nning ck position to he machine from Stop th e machine o n level gr ound when cleaning o r changing the Clean t he inside of t he coolin g system, change the coolant according to the t able below. Antifreeze coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first Minimum Temp °C Above -10 -15 -20 -25 -30 -35 -40 -45 -50 °F Above 14 5 -4 -13 -22 -31 -40 -49 -58 Concentration (%) 30 36 41 46 50 54 58 61 64