Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 27 6. containers to catch the drain ed coolant under drain valve (5) on the radiator side and drain v 7. After draining the antifreeze solution, close drain valve (5), (6), then fill with clean water. Aft er the radiator is filled with water, start and run the engine at temperature rises above 9 about 10 minutes. Stop the engine and open water. After draining the water, clea For the cleaning method, fol Close drain valve (5) and (6) 11. Install the covers (3) and (4) . e water filler up to the bottom of the filler port. ant density, see the COOLANT DENSITY TABLE. 12.

Add Supercoolant through th e water filler up to the bottom of For details of the Supercool 13. Run the engine at low idling f or 5 minutes to remove the air from the water, then run at h igh idling for 5 minutes. (Leave radiator cap (2) remo ved when doing this.) drain the water from sub-tank (7), -tank, then add water to a point marks. ly dirty and it is difficult to clean, rox. 3 minutes, add Supercoolant port, then tighten the radiator cap 14. Open the rear engine hood, drain the water from sub-tank (7), wash the inside of the sub between the FULL and LOW If the sub-tank is extreme replace it with a new part.

wash the inside of the sub between the FULL and LOW If the sub-tank is extreme 15. Stop the engine, wait for app rox. 3 minutes, add Supercoolant up to the bottom of the filler port, then tighten the radiator cap (2). Install cover (1). Close the engine hood. 16. 17.