Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE so inspect the Adjustment WARNING 4 - 29 CHECK AND ADJUST TR Wear on pins and bushings th working cond itions and type track tension every now and then in order to maintain the sta ndard tension. For carrying out inspection a nd adjustment of track shoes, p ark the machine on the flat and Checking 1. 2. 3. Run the engine at low idl e, then move the machine forwa rd for a distance equal to the tra the machine. ck length on ground, and slowly stop 2. Put on the track shoe str aight wooden bar (3) which stretches from idler (1) to upper ca rrier roller (2). eflection between bottom surface of urface of the track shoe. 10 - 30 mm (0.4 - 1.2 in).

Measure the maximum d the wooden bar and top s Deflection "a" should be If the track tension is not at t he standard value, adjust it in th e following man There is danger of plug (1) flying out under the high internal pressure of the grease. Never loosen plug (1) m ore than 1 turn. an plug (1). Never put your face in the oosened with the procedure given here, tributor. Never loosen any part other th mounting direction of plug (1). If the track tension cannot be l If please contact your Komatsu dis Increasing Track Tension Prepare a grease pump. 1. 2. 3. 1. Pump in grease through grease fitting (2) with a grease p ump.

(Grease fitting (2) forms one part with plug (1).) s correct, run the engine at low idle, 2. To check if the tension i move the machine slowly length of track on ground forward (by an amount equal to the ), then stop the machine. Check the track tension a gain, and if the tension is not correct, adjust it again.