CAUTION: Adding water instead of coolant lowers the antifreeze content of the coolant. If water is used instead of coolant, check, and if necessary, correct the antifreeze concentration of the coolant. Use only distilled water. However, soft water may be used if distilled water is not available. If coolant comes into contact with painted surfaces, immediately wash them with water. Do not mix different types of antifreeze. 13.Install: Radiator cap 14.Fill: Coolant reservoir (with the recommended coolant to the maxi- mum level mark a ) 15.Install: Coolant reservoir cap 16.Start the engine, warm it up for several min- utes, and then turn it off. 17.Check:
Coolant level Refer to “CHECKING THE COOLANT LEVEL”. NOTE: Before inspecting the coolant level, wait a few minutes until the coolant has settled. 18.Install: Engine skid plate (rear) Left footrest board Refer to “FOOTREST BOARDS”. Coolant reservoir cover Front fender panel Front carrier Engine side cover Fuel tank side panel (left) Seat Refer to “SEAT, CARRIERS, FENDERS AND FUEL TANK”. 3 - 35 CHANGING THE COOLANT CHK ADJ CHK ADJ