CRANKSHAFT AND OIL PUMP REMOVING THE CRANKSHAFT 1.Remove: Crankshaft Use a crankcase separating tool 1 . CHECKING THE OIL PUMP 1.Check: Rotor housings Rotor cover Cracks/wear/damage Replace. 2.Measure: Tip clearance a (between the inner rotor 1 and the outer rotor 2 ) Side clearance b (between the outer rotor 2 and the pump housing 3 ) Out of specification Replace the oil pump. Tip clearance a : 0.03 ~ 0.10 mm (0.0012 ~ 0.0039 in) : 0.15 mm (0.006 in) Side clearance b : 0.03 ~ 0.10 mm (0.0012 ~ 0.0039 in) : 0.12 mm (0.005 in) 3.Check: Oil pump operation Unsmooth Repeat steps #1 and #2 or replace the defective parts. 4 - 74 ENG Crankcase separating tool: P/N. YU-01135-A, 90890-01135