8.Check: Free movement (piston valve) Sticks Replace the piston valve guide and the piston valve. Insert the piston valve into the carburetor body, and check for free movement. 9.Check: Free movement (throttle valve) Sticks Replace. ASSEMBLING THE CARBURETOR NOTE: Before assembling the carburetor, make sure to turn out the pilot screw the same number of times, as noted before disassembly, from the seated position to the set position. CAUTION: Before assembling, wash all of the parts in a clean petroleum based solvent. 1.Measure: Float height a Out of specification Adjust. ***************************************************** Measurement and adjustment steps:
Hold the carburetor in an upside down posi- tion. Measure the distance from the front mating surface of the float chamber (gasket removed) to the top of the float. NOTE: The float arm should be resting on the needle valve, but not compressing it. If the float height is not within the specifica- tion, inspect the valve seat and needle valve. 6 - 6 CARBURETOR CARB Float height (F.H.): 13 mm (0.51 in)