FRONT AND REAR BRAKES INSTALLING THE REAR BRAKE CALIPER 1.Install: Brake caliper assembly Brake caliper mounting bolt Brake hose Copper washers Union bolt 2.Fill: Brake reservoir CAUTION: Brake fluid may damage painted surfaces or plastic parts. Always clean up spilled brake fluid immediately. WARNING Use only the designated quality brake fluid: other brake fluids may deteriorate the rubber seals, causing leakage and poor brake performance. Refill with the same type of brake fluid: mixing brake fluids may result in a harm- ful chemical reaction and lead to poor brake performance. Be careful that water does not enter the master cylinder when refilling.
Water will significantly lower the boiling point of the brake fluid and may result in vapor lock. Brake system Refer to “BLEEDING THE HYDRAULIC BRAKE SYSTEM” in CHAPTER 3. 4.Check: 3.Air bleed Brake fluid level Brake fluid level is under the “LOWER” level line Fill up. Refer to “CHECKING THE BRAKE FLUID LEVEL” in CHAPTER 3. 8 - 35 CHAS 30 Nm (3.0 m • kg, 22 ft • lb) R. T. s New 30 Nm (3.0 m • kg, 22 ft • lb) R. T. Recommended brake fluid: DOT 4