Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

REMOVING THE REAR BRAKE SWITCH 1.Remove: Rear brake switch 1 NOTE: Push the fastener when removing the rear brake switch out of the rear brake lever holder. CHECKING THE HANDLEBAR 1.Inspect: Handlebar Bends/cracks/damage Replace. Do not attempt to straighten a bent handle- bar as this may dangerously weaken the handlebar. INSTALLING THE HANDLEBAR 1.Install: Handlebar Handlebar holders The upper handlebar holder should be installed with the punched mark 1 forward 2 . CAUTION: First tighten the bolts 3 on the front side of the handlebar holder, and then tighten the bolts 4 on the rear side. INSTALLING THE REAR BRAKE LEVER 1.Install: Handlebar switch 1 Rear brake lever Lever bracket 2 NOTE:

Install the lever bracket as shown. a 66 mm (2.6 in) 8 - 37 STEERING SYSTEM CHAS WARNING WARNING 20 Nm (2.0 m • kg, 14 ft • lb) R. T. NOTE: