Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

REAR KNUCKLE AND STABILIZER CHECKING THE REAR KNUCKLE 1.Check: Rear knuckle Damage/pitting Replace. 2.Check: Rear wheel bearings Bearings allow play in the wheel hubs or the wheel turns roughly Replace. Oil seals Damage Replace. ***************************************************** Replacement steps: Clean the outside of the rear knuckle. Remove the oil seals 1 . Drive out the bearings 2 . WARNING Eye protection is recommended when using striking tools. Remove the spacer 3 . Apply lithium base grease to the bearings and oil seals. Install the spacer to the rear knuckle. Install the new bearings. NOTE: Install the outside bearing first. CAUTION:

Do not strike the center race or balls of the bearing. Contact should be made only with the outer race. Install a new oil seal. NOTE: When installing the oil seals, the “seal side” of the oil seal faces out. ***************************************************** CHECKING THE STABILIZER 1.Check: Stabilizer Bends/cracks/damage Replace. 8 - 51 CHAS