ELECTRIC STARTING SYSTEM EB803020 TROUBLESHOOTING IF THE STARTER MOTOR FAILS TO OPERATE: Procedure Check: 1.Fuse (main, ignition) 2.Battery 3.Starter motor 4.Starter relay 5.Main switch 6.Engine stop switch 7.Gear position switch 8.Rear brake switch 9.Start switch 10.Diode 11.Wiring connection (the entire starting sys- tem) NOTE: Remove the following part(s) before trouble- shooting: 1)Seat 2)Fuel tank side panels 3)Fuel tank 4)Air cleaner case 5)Front carrier 6)Front fender panel Use the following special tool(s) for trouble- shooting. EB802011 EB802012 CORRECT * 9 - 17 ELEC – + Pocket tester: P/N. YU-03112, 90890-03112 1.Fuse (main, ignition) NO CONTINUITY Refer to “CHECKING THE SWITCH”.
CONTINUITY Replace the fuse. Replace the fuse. 2.Battery INCORRECT Check the battery condition. ● Refer to “CHECKING THE BATTERY” in CHAPTER 3. Clean the battery terminals. ● Recharge or replace the battery. ● Clean the battery terminals. ● Recharge or replace the battery. ● Open-circuit voltage: 12.8 V or more at 20 °C (68 °F)