ELECTRIC STARTING SYSTEM * C0NTINUITY Replace the diode. EB803028 9 - 20 ELEC – + 9.Start switch INCORRECT Refer to “CHECKING THE SWITCH”. CORRECT Replace the handlebar switch (left). 10.Diode Remove the diode from the coupler. ● Connect the pocket tester (Ω × 1) to the ● diode terminals as shown. Check the diode for continuity as follows. ● Tester positive probe → Blue/Red 1 Tester negative probe → Black/Yellow 2 Continu- ity Tester positive probe → Black/Yellow 2 Tester negative probe → Blue/Red 1 No conti- nuity CORRECT 11.Wiring connection POOR CONNECTION Check the connections of the entire starting ● system. Refer to “CIRCUIT DIAGRAM”. Properly connect the starting system.