И Fasten the final drive gear case breather hose, speed sensor lead, ground lead, gear position switch lead, AC magneto lead, wire harness, and reverse indicator light lead with a plastic locking tie. Be careful not to pinch the breather hose. Й Fasten the leads in the following order: ground lead, reverse switch lead, speed sensor lead, gear position switch lead, and AC magneto lead. К Pass the final drive gear case breather hose through the hole in air duct assembly 3. Л To the rear fender М 70 ~ 90 mm (2.8 ~ 3.5 in) Н Clamp the thermostat assembly breather hose and carburetor breather hose with the cable guide. О Face the coupler release tab upward.
2 - 35 CABLE ROUTING SPE C A 1 È K 2 C 3 4 5 É B Ê E - E 6 Ë D B 7 Ì E E Í 0 9 8 I 2 D E 8 Ð 7 F C H J G Î B - B 3Ï C D 1 È K 2 C 3 4 5 É B Ê E - E 6 Ë D B 7 Ì E E Í 0 9 8 I 2 D E 8 Ð 7 F C H J G Î B - B 3Ï C D A B D A