CHECKING THE IGNITION TIMING CHECKING THE IGNITION TIMING NOTE: Engine idling speed and throttle cable free play should be adjusted properly before checking the ignition timing. 1.Remove: Seat Fuel tank side panel (left) Engine side cover Refer to “SEAT, CARRIERS, FENDERS AND FUEL TANK”. 2.Attach: Tachometer Timing light (to the spark plug lead) Inductive tachometer: P/N. YU-8036-A Engine tachometer: P/N. 90890-03113 Timing light: P/N. YM-33277-A, 90890-03141 3.Check: Ignition timing ***************************************************** Checking steps: Warm up the engine and keep it at the speci- fied speed. Remove the recoil starter 1 . Remove the timing plug 2 .
Visually check the stationary pointer 3 to verify it is within the required firing range 4 indicated on the flywheel. Incorrect firing range Check the pulser coil assembly. Install the timing plug. Install the recoil starter. Recoil starter bolt: 14 Nm (1.4 m • kg, 10.1 ft • Ib) LOCTITE ® T R . . ***************************************************** 3 - 23 CHK ADJ CHK ADJ Engine speed: 1,450 ~ 1,550 r/min