. OPERATION DETAILED CONTROLS AND GAUGES CIRCUIT BREAKER NOTICE When resetting the circuit breaker, always turn the starting switch OFF first. 3 - 69 If the st switch is arting switch does not turned ON, open the work even when the circuit breaker box in starting side the grease p inspectio ump box at the front righ t of the machine and carry out n. ess current is generated, the circuit breaker cuts off If an exc electrical from dam after it ha If the el remains it is push current to protect elec age. To return the circ trical components an uit electrical current t d wiring o normal s been cut off, push in the reset button. g normally, the rese t button ectric circuit is workin in.
If the reset button po ps out again immedia tely after ed in, it is necessary to check the electric circ uit. REMARK uit breaker is a circuit protection device installed to The circ circuits compon current i restoring replace t where large current flo ents and wiring from da ws. It protects the electrical mage caused by an a bnormal n the same way as a no rmal fuse. After repa iring and the location of the ab normality, there is no need to sed again. work even when the starting he breaker. It can be u If the st arting motor does not switch is cut off th turned to the ON positio n, breaker (8), (9) has probably e circuit, so check and restore circuit breaker (8), (9).
If the ele ctrical equipment does not work even when th e fuse is replaced check a , breaker (1) or (11) has probably cut off the c ircuit, so nd restore circuit breake r (1) or (11). Fu No. cap se Name of circuit acity (1) 4 0A Fuse box (2) 4 0A Circuit breaker No. 4 - 7 (3) 4 0A Circuit breaker No. 8 - 11 (12) 2 0A Electric priming pump switch timer