. OPERATION DETAILED CONTROLS AND GAUGES OPERATION DETAILED CONTROLS AND GAUGES REMARK Put the spare grease can beside the grease pump in the grease pump box at the right side of the machine. 3 - 74 3. Fill grease can (1) with fresh grease, set follow pl ate (4) on top of the grease so th until grease comes plate (4). When setting th inside of the rais grease. This wil of the grease so th at it is horizontal, then push d own by hand until grease comes out from the packing in the ce nter of follow plate (4). When setting th e follow plate on top of the grease, fill the ed part in the center of the foll ow plate with l make the operation go more smoothly. 4.
Insert the pump into the packing at the center of fo llow plate (4), set cover (3) on gr uniformly to hold in The pump will op first grease inclu and not suitable set cover (3) on gr ease can (1), then tighten 3 wing bolts (2) position. uniformly to hold in The pump will op erate for a short time and then stop, but the des air inside the pump, so it is cloudy white for use. 5. Loosen check valv e (5), and pump out all the grea se which has air in it from hole (6 ) at the bottom of check valve (5). rely. 6. After bleeding the air, close check valve (5) secu 7.
After bleeding the a ir inside the pump, pull the lev er of the greas e gun to completely disc harge the grease mixed with air inside the h When filling with portion. If there is ample set in position, s The standard gr be more grease with air inside the h ose and grease gun. When filling with grease, be extremely careful not to let san d or dirt stick to the follo w plate or pump suction If there is ample grease, but the pump does n ot pump out a ny grease,the follow pla te may not be correctly o set it in position again corre ctly. The standard gr ease can contains 16 liters (4. 23 US gal). If an 18 liters (4.76 US gal ) can is used, there will left.