. OPERATION MACHINE OPERATIONS AND CONTROLS Check Fuel Level, Add Fuel WARNING Check for Water and Sediment in Water Separator, Drain Water 1. Open the engine room door. 2. The water separator forms one unit with fuel pre-filter (1). 3 - 80 When adding fuel, never let the fue l overflow. This may cause a fire. If any f uel is spilled, wipe it up comple tely. Never bring flames near fuel because it is highly flam mable and dangerous. 1. Open fuel filler cap (F) of t he fuel tank. 2. When fuel filler cap (F) is o pened, float gauge (G) comes up in proportion to the remainin Check that the fuel tank is Inspect the fuel level both g fuel level in the tank. full.
visually and with float gauge (G). 3. If the fuel tank is not full, ad d fuel through the fuel filler until float gauge (G) rises to the ma Fuel tank capacity: 1360 li Position of tip (a) of float Approx 50 mm (2 in) ximum position. ters (359.31 US gal) gauge (G) when fuel tank is full: 4. After refilling with fuel, pus h float gauge (G) straight down with fuel filler cap (F) and then tighten the cap securely. REMARK I f the fuel tank breather gets cl ogged, pressure inside the fuel tank goes down and fuel may not be sent, so clean the breather element every now and then.
If pressu re inside the fuel tank remains low and fuel is not sent even thou gh the breather has been cleaned, replace the breather element with a new one, seeing "REPLACE MENT (PAGE 4-66)". FUEL TANK BREATHER ELE 3. It is possible to judge the water level and amount of sediment by looking through transpa sediment collected at the drain water under drain ho rent cap (2). If there is any water or bottom, set a container to catch the se (3). d drain the water. from drain hose (3), tighten drain 4. Loosen drain valve (4) an 5. When fuel starts to drain valve (4) immediately. Tightening torque: 0.2 to 0. lbft) 45 Nm (0.02 to 0.046 kgm, 0.1 to 0.3