Komatsu — TRAVELING ON SLOPES

. OPERATION MACHINE OPERATIONS AND CONTROLS TRAVELING ON SLOPES WARNING Turning or operating the work equipment when working on slopes may cause the machine to lose it balance and turn over, so avoid such 3 - 129 operations. Itis particularly dang If such operations h erous to swing downhill when the bucket is loaded. ave to be performed, pile soil to make a platform (A) on the slope so the machine is kept horizon tal during o peration. Do not work on a sl ope covered with the ste el plates. Even with s light slopes there is a haz ard that the machine m ay slip. Do not travel up or d own steep slopes. There is danger t hat th e machine may turn over. When traveling, rais ground.

e the bucket approx. 20 to 30cm (8 to 12 in) from the Do not travel downh Never turn on slope Always go down to ill in reverse. s or travel across slopes. a flat place to perform these operations. It may be longer, but it will en sure safety. Always operate or tr avel in such a way that i t is possibl e to s top s afely at any time if the ma chine slips or becomes unstable. 1. When traveling d own steep hills, use the travel lever and fuel c e l ontrol lever to k eep the travel speed low. than 15°, set the work When traveling down slopes of more work quipment in the posture shown in the figure on the right, and ower the engine speed. 2.

When traveling u p a steep hill of more than 15° , set the work e quipment to the posture shown in the diagram on th e rig ht.