. OPERATION MACHINE OPERATIONS AND CONTROLS BUCKET REPLACEMENT WARNING 3 - 133 Wh en pins are knocked in with a hammer, pieces of me tal may fly and cause seriou s injury en carrying out this op eration, always wear goggles , hard hat, gloves, and other protective e quipment. Wh en the bucket is remov ed, place it in a stable condit If p ins are hit with a strong force, there is a hazard that th e pin may fly ou t and i njure p eople i n the surrounding area. Ma ke sure t there is no one in the surrounding area before star ting the operation. Wh en removing the pins, d o not stand behind the bucke t.
In addition, be extremely ca reful n ot to p ut your foot under the bucket le standing at the side Wh en removing or insertin g pins, be extremely careful not to get your f ingers caugh Nev er insert your fingers i nto the pin holes when aligni ng the holes. Stop the machine on a firm and flat surface and do t he work. When performing joint work , appoint a lead and follow that p erson's instructions Replacement 1. P lace the bucket in co NOTIC E removing the bucket, set the bucket cylinder (5) facing down as When as shown in the diagram in the ri ght to prevent the front link ( 4) from jumping up un der the weight of the bu cket cylinder (5).
REMA RK removing the pins, place the bucket so that it is in light ct with the ground. bucket is lowered strongly to the ground, the resistance will reased and it will be difficult to remove the pins. When conta ct with the ground. If the bucket is lowered str ongly to the ground, the resistanc be inc reased and it will be difficult to remove the pin