Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE CHECK AND ADJUST TRACK TENSION WARNING For details of starting the engine and operating the work equipment, see "BEFORE STARTING ENGINE (PAGE 3-75)", "STARTING ENGINE (PAGE 3-101)", and CONTROLS AND so inspect the Checking the machine. No. 3 roller (2). bottom surface of 4 - 24 ENGINE (PAG E 3-98)" NS (PAGE 3-119 )" in the OPERATION sect "WORK EQUIPMEN s and bushing s of th e undercarriage working conditio ns and track tension every now an d then in order to main tain the standard tension. For carrying out inspection and a djustment of trac k shoes, par k the machine on the fla t and solid 1.

Run the engine at low i dle, th en move the mac hine forward for e equal to the track l ength on ground, and slowly s top 2. Place wo oden bar (3) o n top o f the track from No. 2 roller (1 ) to 3. Measure the maximum en bar and to p surfa ce of the track s n "a" should b e 10 - 30 mm (0.4 - 1.2 If the track te nsion is not a t the st andard value, a djust it in the following manne