. MAINTENANCE MAINTENANCE PROCEDURE 4 - 34 CLEAN LINE FILTER, REMOVE DIR I f there is any abn ormalit y in the pu equipment, remove t he dirt f rom inside th e line filter as follow Before r emoving t he dirt f in the rom inside t release the internal pressure hydraulic c etails, see "METHO D OF R YDRAULIC CIRCUIT 1. Remov e cover (1 2. Install a bolt (10 m m, 0.4 in) in bolt hol e (A) of eleme nt (2), then hold th e bolt and pull out element (2) 3. Clean e lement (2 Whe n cleanin g the element, clean the dirt and d ust stu ck to side surface ( B) of th e filter case. 4. Replac e O-ring ( 3) of element (2) wit h a new part, then in sert elemen t (2) into t he filter case. and O-ring ( 5.
Replac e backup ring (4) parts, t hen install cover ( 1) to the filte Tightening torque of cover (1): 181 N m (18.5 kgm, 133.8 lbft) Afte r assembling the line filte r again, blee d the air. For details, see "BLEEDING AIR FRO M HYDRAULIC SYSTEM (PAGE 4-3 6)".