Cab Body Cab entry step All vehicles with steel suspension on the rear axle are fitted with a movable cab entry step. The non- slip step is made of thermoplastic and is mounted on sturdy but flexible rubber tabs. These vehicles, with the exception of the all-wheel drive vehicles, can optionally be equipped with the fixed cab entry step, but this can only be installed together with the front underride guard (ECE), aluminum (C7F). Air-sprung vehicles feature the fixed cab entry step as standard.
W60.80-1180-00 Fixed cab entry step (F7X) W60.80-1181-00 Movable cab entry step (F7Y) Guard plate under bumper (M7J) All vehicles with steel suspension are equipped with a guard plate under the bumper (M7J) as standard. The guard plate is available as an option for air- sprung vehicles. The guard plate is made of 2 mm thick stainless steel sheet. The option for the omission of the guard plate under the bumper (M9V) increases the front angle of approach. W88.30-1034-00 Guard plate under bumper (M7J) 70 Introduction of the New Truck Generation - The New Arocs (Model 964) i – This printout will not be recorded by the update service. Status: 01 / 2013 –