Kubota — Draining Clutch Housing Water

87 PERIODIC SERVICE SERVICE AS REQUIRED B Bleeding Fuel System Air must be removed: 1. When the fuel filter or lines are removed. 2. When water is drained from water separator. 3. When tank is completely empty. 4. After the tractor has not been used for a long period of time. A Do not hold key switch at engine start position for more than 10 seconds continuously. If more engine cranking is needed, try again after 30 seconds. 4. Accelerate the engine to remove the small portion of air left in the fuel system. 5. If air still remains and the engine stops, repeat the above steps. C Bleeding procedure is as follows: 1. Fill the fuel tank with fuel, and open the fuel cock.

B Bleeding Brake System Consult your local KUBOTA Dealer for this service. B Draining Clutch Housing Water The tractor is equipped with a drain plug under the clutch housing. After operating in rain, snow or if the tractor has been washed, water may get into the clutch housing. Remove the drain plug and drain the water, then install the plug again. (1) Fuel cock (A) "CLOSE" (B) "OPEN" 2. Pump the fuel pump knob(1) located on the top of the fuel filter. The fuel pump knob will pump easily at first and with added resistance as air is purged from the system.

To make sure air is completely purged, pinch the fuel overflow hose with fingers, if a pulsation is felt when the knob is pumped, then, no air remains. (1) Water drain plug (1) Fuel pump knob (2) Fuel overflow hose (A) "UP" (B) "DOWN" 3. Set the hand throttle lever at the maximum speed position, turn the key switch to start the engine and then reset the throttle lever at the mid speed (around 1500 rpm) position. If engine doesn't start, try it several times at 30 second intervals.