45 HYDRAULIC UNIT B Remote Control Valve Lever The remote control valve lever directs pressurized oil flow to the implement hydraulic system. A Do not hold the lever in the "REARWARD" or "FORWARD" position once the remote cylinder has reached the end of the stroke, as this will cause oil to flow through the relief valve. Forcing oil through the relief valve for extended periods will overheat the oil. A When using the tractor hydraulic system to power front loader, do not operate boom and bucket cylinders simultaneously. A Connect the pressure of load side of implement cylinders to ports [B] or [D] which have built in load check valve to prevent leak down.
B Remote Control Valve Coupler Connecting and Disconnecting (1) (2) Remote control valve lever 1 Remote control valve lever 2 (X) (Y) (Z) "REARWARD" "FORWARD" "DETENT POSITION" To avoid personal injury or death: A Stop the engine and relieve pressure before connecting or disconnecting lines. A Do not use your hand to check for leaks. C Connecting 1. Clean both couplers. 2. Remove dust plugs. 3. Insert the implement coupler to the tractor hydraulic coupler. 4. Pull the implement coupler slightly to make sure couplers are firmly connected. C Disconnecting 1. Lower the implement first to the ground to release hydraulic pressure in the hoses. 2. Clean the couplers. 3.
Relieve pressure by moving hydraulic control levers with engine shut off. Pull the hose straight from the hydraulic coupler to release it. 4. Clean oil and dust from the coupler, then replace the dust plugs. Pressure Returning A Your local KUBOTA Dealer can supply parts to adapt couplers to hydraulic hoses. Lever (1) Lever position Z Y X Z Port (A) out in (B) in out Lever (2) Lever position Z Y X Z Port (C) out in (D) in out