Kubota — Checking Engine Start System

PERIODIC SERVICE 68 B Checking Head Light, Turn Signal / Hazard Light etc. 1. Inspect the lights for broken bulbs and lenses. 2. Replace if broken. C Test: Checking Operator Presence Control (O.P.C.) System. 1. Follow the instruction of "PARKING THE TRACTOR". (See "PARKING THE TRACTOR" in "SAFE OPERATION" section.) 2. Make sure the PTO drive shaft is disconnected from the tractor. 3. Sit on the operator's seat. 4. Start the engine. 5. Engage the PTO clutch control switch or lever. The PTO should begin to rotate. Disengage the PTO clutch control switch or lever. 6. While lifting yourself from the seat, engage the PTO clutch control switch or lever.

(1) The PTO should begin to rotate and a buzzer should sound. (2) Disengage the PTO clutch control switch or lever. (3) If the buzzer does not sound, shut off the engine and consult your local KUBOTA Dealer for immediate servicing of the PTO OPC. 7. If the PTO OPC is operating properly, shut off the engine, and reconnect the implement drive shaft to the PTO. Restart the engine per the available instructions. B Checking Seat Belt 1. Always check condition of seat belt attaching hardware before operating tractor. 2. Replace if damaged. EVERY 50 HOURS B Checking Engine Start System To avoid personal injury or death: A Do not allow anyone near the tractor while testing.

A If the tractor does not pass the test, do not operate the tractor. C Preparation before testing. 1. Place all control levers in the "NEUTRAL" position. 2. Set the parking brake and stop the engine. To avoid personal injury or death: A Before checking the PTO OPC, make sure that the PTO drive shaft should be disconnected from the tractor. A If the buzzer does not sound during the PTO OPC check procedure, shut off engine and consult your local KUBOTA Dealer for immediate servicing of the PTO OPC. A The unit should not be operated until servicing is completed. C Test: Switch for the shuttle shift lever. 1. Follow the instruction of "PARKING THE TRACTOR".

(See "PARKING THE TRACTOR" in "SAFE OPERATION" section.) 2. Sit on the operator's seat. 3. Shift the shuttle shift lever to the forward or reverse position. 4. Depress the clutch pedal fully. 5. Disengage the PTO clutch control switch or lever. 6. Turn the key to "START" position. 7. The engine must not crank. 8. If it cranks, consult your local KUBOTA Dealer for this service. C Test: Switch for the PTO clutch control switch or lever. 1. Follow the instruction of "PARKING THE TRACTOR". (See "PARKING THE TRACTOR" in "SAFE OPERATION" section.) 2. Sit on the operator's seat. 3. Engage the PTO clutch control switch or lever. 4. Depress the clutch pedal fully. 5.

Shift the shuttle shift lever to the neutral position. 6. Turn the key to "START" position. 7. The engine must not crank. 8. If it cranks, consult your local KUBOTA Dealer for this service. (1) Shuttle shift lever (2) Clutch pedal (3) PTO clutch control switch