Komatsu — BRAKE OIL LEVEL SENSOR

STRUCTURE AND FUNCTION SENSORS AND SWITCHES SENSORS AND SWITCHES Function For the sensors which send the signal directly to the ! There are three types of sensor: contact type, monitor, if the contacts are closed (when the monitor is resistance type, and electromagnetic type. connected to the ground), the monitor judges that the ! One end of the contact type sensor wiring is signal is normal. connected to the chassis ground; the other end For the sensors which send the signal to the monitor either sends the signal from the sensor directly to through a relay, if the contacts are open, the monitor the monitor or sends it through a relay. judges that the signal is normal.

(The signal is reversed by the relay). BRAKE OIL LEVEL SENSOR 1. Cap 2. Ring 3. Diaphragm 4. Tank 5. Connector Function ! The brake oil sensor is installed to the bottom of the brake oil tank. If the brake oil goes below the specified level, the float goes down and the switch is turned ON. This actuates the relay, turns the relay output OFF, and makes the machine monitor lamp flash to warn the operator of the abnormality.

10-122 Sensor detection item Sensor type When normal When abnormal Brake oil level Contact OFF ON Engine oil level Contact ON OFF Radiator water level Contact ON OFF Fuel level Resistance Engine oil pressure Contact OFF ON Engine water temperature Resistance Torque converter oil temperature Resistance Travel speed Electromagnetic