Komatsu — ENGINE SPEED SENSOR

STRUCTURE AND FUNCTION SENSORS AND SWITCHES ENGINE SPEED SENSOR 1. Magnet 2. Terminal 3. Case 4. Boot 5. Connector Function ! The engine speed sensor is installed to the ring gear portion of the flywheel housing. A pulse voltage is generated by the rotation of the gear teeth, and a signal is sent to the controller and monitor panel. ENGINE OIL PRESSURE SENSOR 1. Plug 2. Contact ring 3. Contact 4. Diaphragm 5. Spring 6. Terminal Function ! This sensor is installed to the engine block and the diaphragm detects the oil pressure. If the pressure goes below the specified pressure, the switch is turned ON, and a relay is actuated to turn the output OFF.

This makes the maintenance monitor flash to warn of the abnormality. The caution lamp and alarm buzzer are also actuated at the same time to warn of the abnormality. 10-126