TESTING AND ADJUSTING MEASURING ENGINE SPEEDS MEASURING ENGINE SPEEDS When removing or installing the measuring equipment, be careful not to touch any high temperature parts. i Measure the engine speed under the following conditions. Coolant temperature: Within operating range Torque converter oil temperature: 70 to 90 E C (158 - 194 E F) Hydraulic oil temperature: 45 to 55 E C (113 - 131 E F) 1. Install the digital optical tachometer using the instruction supplied with it. 1) Remove the cap 1 of engine speed output, and then install adapter ass’y A2. 2) Connect the tachometer A1 and adapter ass’y A2 with cable.
When measuring engine speeds, be careful not to touch any high temperature parts or rotating parts. 2. Start the engine, and measure the engine speed when it is set to the conditions for measuring. 1) Measuring low idle and high idle speeds. 2) Measure the speed at near the rated speed. i When measuring speeds for items other than the above, such as torque converter stall, see the procedure for the item as described in this section. 20-12