Komatsu — MEASURING AND ADJUSTING WORK EQUIPMENT CONTROL LEVER

TESTING AND ADJUSTING MEASURING AND ADJUSTING WORK EQUIPMENT CONTROL LEVER MEASURING AND ADJUSTING WORK EQUIPMENT CONTROL LEVER i Measurement conditions C Engine water temperature: Within white range on engine water temperature gauge. C Hydraulic oil temperature: 45 - 55 E C (113 - 131 E F) C Engine speed: Low idling. Install the safety bar to the frame. Measurement method 1. Operating effortof work equipment control lever Install tool I to the work equipment control lever and measure the operating force. i Install tool I to the center of the knob. i Operate the control lever at the same speed as for normal operations, and measure the minimum value for the force needed to operate the knob.

2. Travel of work equipment control lever Measure travel at each position when operating the work equipment control lever. i Mark the lever knob and use scale K to measure. i If the travel is not within the standard value, check for play of the linkage and wear of the bushing. Adjusting 1. Adjusting linkage rod of work equipment control lever 1) Remove top cover (1) and front cover (2) of the right console. 2) Assemble the work equipment cable at the control valve end (inside front frame) to standard length a . Adjust the length with control cable mounting nut (3) or yoke (4). i Standard length a : 173 mm 20-42