TROUBLESHOOTING POINTS TO REMEMBER WHEN TROUBLESHOOTING POINTS TO REMEMBER WHEN TROUBLESHOOTING Stop the machine in a level place, and check that the safety pin, blocks, and parking brake are securely fitted. When carrying out the operation with two or more workers, keep strictly to the agreed signals, and do not allow any unauthorized person to come near. If the radiator cap is removed when the engine is hot, hot coolant may spurt out and cause burns, so wait for the engine to cool down before starting troubleshooting. Be extremely careful not to touch any hot parts or to get caught in any rotating parts.
When disconnecting wiring, always disconnect the negative (-) terminal of the battery first. When removing the plug or cap from a location which is under pressure from oil, water or air, always release the internal pressure first. When installing measuring equipment, be sure to connect it properly. The aim of troubleshooting is to pinpoint the basic cause of the failure, to carry out repairs swiftly, and to prevent reoccurrence of the failure. When carrying out troubleshooting, an important point is to understand the structure and function of the machine.
However, a short cut to effective troubleshooting is to ask the operator various questions to form some idea of possible causes of the failure that would produce the reported symptoms. 1. When carrying out troubleshooting, do not hurry to 5. Other maintenance items can be checked disassemble the components. If components are externally, so check any item that is disassembled immediately after a failure occurs: considered to be necessary. ! Parts that have no connection with the failure or 4. Confirming the failure. other unnecessary parts will be disassembled. 1. Confirm the extent of the failure yourself, and judge !
It will become impossible to find the cause of the whether to handle it as a real failure or as a failure. problem with the method of operation, etc. It will also cause a waste of man hours, parts, or oil i When operating the machine to reenact the and grease. At the same time, it will also lose the troubleshooting symptoms, do not carry out any confidence of the user or operator. For this reason, investigation or measurement that may make the when carrying out troubleshooting, it is necessary to problem worse. carry out thorough prior investigation and to carry out 5. Troubleshooting troubleshooting in accordance with the fixed 1.
Use the results of the investigation and inspection procedure. in Steps 2 - 4 to narrow down the causes of the 2. Points to ask the user or operator. failure, then use the troubleshooting flowchart to 1. Have any other problems occurred apart from the locate the position of the failure exactly. problem that has been reported? b The basic procedure for troubleshooting is as 2. Was there anything strange about the machine follows. before the failure occurred? 1. Start from the simple points. 3. Did the failure occur suddenly, or were there 2. Start from the most likely points. problems with the machine condition before this? 3. Investigate other related parts or information. 4.
Under what conditions did the failure occur? 6. Measures to remove root cause of failure. 5. Had any repairs been carried out before the 1. Even if the failure is repaired, if the root cause of failure? When were these repairs carried out? the failure is not repaired, the same failure will 6. Has the same kind of failure occurred before? occur again. 3. Check before troubleshooting. 2. To prevent this, always investigate why the problem 1. Check the oil level. occurred. Then, remove the root cause. 2. Check for any external leakage of oil from the piping or hydraulic equipment. 3. Check the travel of the control levers. 4. Check the stroke of the control valve spool. 20-103 WA250-3L